Message 5 of If it is not, then you know to check cables, confirm power, and verify that the instrument is working properly. If there is one, then uninstall the Keithley driver then load the NI driver. Help the Community and future reviewers by marking posts as follows: And also the device’s driver. But I don’t know HOW?

Uploader: Arashakar
Date Added: 7 January 2014
File Size: 63.37 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 44800
Price: Free* [*Free Regsitration Required]

Yes, if it works, you should always go for the VISA comm.

I have attached the screenshot Message 5 of gpbi I have its manual with the list of commands. As I understood this is your case, yes?

Be sure you have VISA driver already installed! If not, you can get it here: The basic functions and concepts described above may seem simple; however, they can be invaluable in troubleshooting and getting your GPIB system up and running.

Installing GPIB-USB Controllers

What is your exact goal? I did as you said.

Once you have completed these steps, you need a fast way to progress from interactive mode to programming mode so you can immediately begin writing your tests without a tedious transition process. Advancing Automation eBook Series. If there is one, then uninstall the Keithley driver then load the NI driver. With this test panel, you can set properties for your instrument communication as well as read and write to the instrument.


The linear profile rails are mounted to a machined aluminum base, which offers support over the entire travel of the table’s carriage.

Keithley b-gpib-usb GPIB to USB Adapter | eBay

It jeithley important to choose an alias that you can immediately identify with the intended instrument. As I saidWhen trying to interact with the instrument Lock-in-Amplifier using Keithley diagnostic tool and configuration, I am able to communicate with my Lock-in-Amplifier It will find the driver, then install it.

You can also find these at ni. If we cannot see “what you did wrong”, we are unable to tell you how to fix it.

Your instrument should return an identification string and a return count. Because the GPIB signals at each end are transformed into fiber-optic signals, each unit keithlye reside at a different ground potential.

Keithley Introduces KUSBB USB-To-GPIB Adapter |

If you have two or more instruments on the bus, you can disconnect all instruments except one to determine its address. The best way to achieve this is by using instrument drivers. Message 10 of Instruments must be powered on and connected to the GPIB controller to be recognized. Many times, systems are powered down and cables are disconnected from instruments for maintenance or system configuration changes.


Bob Schor 28 August When VISAIC initially runs, it automatically finds all of the available resources in the system and lists the instrument descriptors for each resource under the keithleu resource type.

The new version works to enable factories to streamline machinery repairs and diminish production downtime through IT-managed secure access.

Keithley 2260b-gpib-usb GPIB to USB Adapter

When trying to interact with the instrument Lock-in-Amplifier using Keithley diagnostic tool and gpibb, I am able to communicate with my Lock-in-Amplifier.

Did you make the required settings under MAX what was told you here?: If your computer is already running, the operating system automatically detects the GPIB interface. This database, called FLUIDAT, is used by the keityley for configuration and calibration of its portfolio of flow meters and controllers, and for What I observed is: